Windows-G E-ChorusFX700 (VST3)E-ChorusFX700 is a Windows-only VST3 chorus plugin that can be used to add depth, width, and modulation movement to tracks and mixes. Features: * Two LFO Shapes: 1. Triangle: Because a triangle wave moves at a constant speed in both directions (up and down), it produces less obvious volume and pitch variations in the chorus sound. 2. Sine: Because a sine wave moves slowly at the peaks and troughs then accelerates through the middle, it produces more noticeable volume and pitch variations in the chorus sound. * Delay (0–50 ms): Sets the base delay time for the LFO modulation. Short delays (0.1–5 ms) create a sweeping, flanger-like effect due to comb filtering. Mid-range delays (6–12 ms) produce transparent, single-voice chorus. Longer delays (13–50 ms) produce highly spacious chorus with more noticeable doubling. * Depth (0–100%): Controls how far the modulation sweeps above and below the base delay time; this is the intensity of the modulation. Lower values create narrower sweeps, giving a subtle chorus effect, while higher values create wider sweeps, resulting in a more intense chorus effect. At 0%, there's no modulation, while at 100%, the modulation uses the full range of the delay time. * Rate (0–15 Hz): Controls the speed of the modulation. Lower rates create slow, gentle detuning, while higher rates create a faster, more vibrato-like effect. * Width (0–100%): Controls the stereo width by offsetting the phase relationship between the left and right channels. At 0%, the modulation pattern is mono (identical on both channels), creating a centered chorus. At 100%, the channels are fully out of phase, creating a wide stereo chorus. * Dry (0–100%): Controls the level of the dry, unprocessed signal. At 0%, the dry signal is completely removed, while at 100% it is at full level. * Wet (0–100%): Controls the level of the wet, processed signal. At 0%, the wet signal is completely removed, while at 100% it is at full level. * Wet HPF (10 Hz – 20 kHz): Applies a high-pass filter to the wet signal only. The filter becomes active only when the frequency is set above 10 Hz. It can be used to roll off low frequencies to focus the chorus effect on the mids and highs. * Wet LPF (20 Hz – 21 kHz): Applies a low-pass filter to the wet signal only. The filter becomes active only when the frequency is set below 21 kHz. It can be used to roll off high frequencies to create a darker chorus effect. * Output Gain (dB): Sets the final output level of the plugin from -30 dB to +30 dB to compensate for volume changes. * Visual Indicators: Display the selected LFO shape (Triangle or Sine) and the active status of the wet high-pass and low-pass filters. * GUI Bypass Button: A smooth bypass button for toggling the effect on or off without audio clicks. It is available for automation as "Bypass (Smooth)" in the plugin's parameter list. * High-DPI scaling support: The current GUI scale is shown as a percentage in the top-left corner of the plugin, and clicking it brings up the "UI Zoom" options for increasing the size of the plugin interface. As an alternative, provided your DAW/host doesn't intercept a right-click event on a plugin's window, right-clicking anywhere on the GUI brings up the same "UI Zoom" options. * Double-click sliders to reset them to their default values. Hold Ctrl while clicking and dragging for fine slider increments. * Arrow key support for sliders: click a slider to bring it into focus, then use the arrow keys on the keyboard to move it. * 12 Factory Presets: The plugin comes with 12 built-in presets that can be navigated via mouse click or the up/down arrow keys on the keyboard. You can grab it for FREE. Listen to the audio demos on the right or visit the Gumroad product page to hear what the plugin can do. Email Support: info.windowsg@gmail.com Read More